====== TQMa35 configuring U-Boot ======

===== Kenel via TFTP and rootfs via NFS =====
This describes how to configure the U-Boot, to boot the kernel via TFTP and the rootfs via NFS on the TQMa35. The TQMa35 must be started to get into U-Boot. Stop the auto-boot countdown by pressing a key. The following must be configured in the U-Boot command shell:
<code>
MX35 U-Boot > setenv kernel uImage
MX35 U-Boot > setenv rootpath /opt/ltib_iMX35/ltib/rootfs
MX35 U-Boot > setenv serverip 172.21.10.214
MX35 U-Boot > setenv bootcmd run net_nfs
MX35 U-Boot > saveenv
</code>

===== Flash Linux kernel via TFTP =====
Similar to the update of U-Boot the following commands have to be set once in the U-Boot command shell to update or install a Linux kernel image in flash memory:
<code>
MX35 U-Boot > setenv prg_kernel tftpboot ${loadaddr} ${kernel}; erase ${kernel_addr} A02FFFFF; cp.b ${loadaddr} ${kernel_addr} ${filesize};
MX35 U-Boot > saveenv
</code>

And then the actual update of the Linux image:
<code>
MX35 U-Boot > run prg_kernel
</code>

===== Flash rootfs via TFTP =====
Also for the root file system. Once to set:
<code>
MX35 U-Boot > setenv ramdisk_end a1ffffff (for 32MB of flash)
MX35 U-Boot > setenv rootfs rootfs.jffs2
MX35 U-Boot > setenv prg_rootfs tftpboot ${loadaddr} ${rootfs}; erase ${ramdisk_addr} ${ramdisk_end}; cp.b ${loadaddr} ${ramdisk_addr} ${filesize};
MX35 U-Boot > saveenv
</code>

And for each update of the rootfs:
<code>
MX35 U-Boot > run prg_rootfs
</code>