en

Embedded module TQM6ulx - QNX BSP documentation

  • Overview
  • Downloads
  • FAQ
  • How To
  • Known Issues

Overview

due to licensing restrictions this BSP is available only on request

Bootloader

Supported features

Feature BSP Revision Remarks
TQ Product Chip Interface Function Prerelease
TQMa6ULx i.MX6UL Ethernet RMII (10/100 Mbit/s)
TQMa6ULx i.MX6UL uSDHC eMMC / SD-Card SD card / eMMC
TQMa6ULx i.MX6UL UART1 RS232 default console
TQMa6ULx i.MX6UL I²C EEPROM
TQMa6ULx i.MX6UL GPIO custom config on request
TQMa6ULx i.MX6UL SPI QSPI NOR Flash
TQMa6ULx i.MX6UL IIM / Fuse on request


Supported boot devices

Boot device supported
eMMC
SD Card

Operating System

Supported Features

Feature BSP Revision Remarks
TQ Product Chip Interface Function QNX 6.6 QNX 7.0.0
TQMa6ULx i.MX6UL eCSPI2 No device on MBa6ULx
i.MX6UL ENET1 RMII
(10/100 Mbit/s)
i.MX6UL ENET2 RMII
(10/100 Mbit/s)
i.MX6UL FLEXCAN1 CAN 2.0B
i.MX6UL FLEXCAN2 CAN 2.0B
i.MX6UL FLEXTIMER On request
i.MX6UL GPIO 1x GPIO On request
i.MX6UL GPMI Multiplexed with other functions
(on request), no device MBa6ULx
i.MX6UL I2C2 Not available by default
configuration resistor R451 and R455
i.MX6UL I2C4 I2C devices RTC DS1339 other device on request
i.MX6UL eLCDIF Parallel LCD Q4/2017 Q4/2017 24-bit interface available via X4
LVDS Q4/2017 Q4/2017 24-bit available via X17
i.MX6UL MIPI CSI No device on MBa6ULx
i.MX6UL MIPI DSI No device on MBa6ULx
i.MX6UL PWM2 Buzzer On request
i.MX6UL PWM4 Backlight Dimming On request
i.MX6UL QSPI Bus access
Memory access
On request
i.MX6UL SAI1 Audiocodec On request
Support for Codec WM8960 available
i.MX6UL TEMPMON CPU temperature read on request
i.MX6UL UART1 RS232/
USB Debug
Default console / USB debug connector
selectable with S15 on MBA6ULx
i.MX6UL UART2 TTL Multiplexed with other functions (on request)
i.MX6UL UART3 TTL Not available on MBa6ULx
i.MX6UL UART4 TLL Multiplexed with other functions (on request)
i.MX6UL UART5 TLL Multiplexed with other functions (on request)
i.MX6UL UART6 RS485
i.MX6UL UART7 TLL Multiplexed with other functions (on request)
i.MX6UL UART8 TLL Multiplexed with other functions (on request)
i.MX6UL USB_Host USB2517
i.MX6UL USB_OTG1 Host Only Host supported
i.MX6UL USB_OTG1 OTG Q3/2017 Q3/2017 ACM (Serial), NCM (Ethernet), CDC Mass Storage
i.MX6UL USB_OTG2 Host Only Host supported
i.MX6UL USB_OTG2 OTG Shared with USB2517 Hub [7:1]
i.MX6UL uSDHC1 SD Card (4-bit) QNX6 Power Fail Filesystem
i.MX6UL uSDHC1 eMMC (8-bit) Q3/2017 QNX6 Power Fail Filesystem
(Optional Encryption)
MBa6ULx TLV320AIC3204 Headphone Out/
Line Out
On request
Line In On request
Microphone In On request
PCA9554BS I2C GPIO expander On request
PCA9554BS I2C GPIO expander On request
SIM Not tested
Available on Connector X22 on MBa6ULx
STMPE811 resistive touch controller Q4/2017 Q4/2017 Connected to I2C4 on MBa6ULx
USB2517 USB1 Host 1 MBa6ULx X7 top
USB2517 USB2 Host 2 MBa6ULx X7 bottom
USB2517 USB3 Host 3 MBa6ULx X8
USB2517 USB4 Host 4
USB2517 USB5 Host 5
USB2517 USB6 Host 6
USB2517 USB7 Host 7
SNVS Reset Reset
PMIC-Reset
Power-Down
Wake-Up


Onboard I2C devices


I2C bus TQMa6ULx MBa6ULx
I2C4 0x08
PMIC
0x1A
Tempsensor
0x50
EEPROM
0x52
EEPROM
0x68
RTC
0x18
Audiocodec
0x19
Tempsensor
0x20
GPIO Expander
0x21
GPIO Expander
0x41
Touch Controller
0x51
EEPROM


en/arm/tqma6ulx/qnx.txt · Last modified: 2017/07/10 16:33 by liedmann

 

Disclaimer

TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International


Recent changes RSS feed Valid XHTML 1.0 Valid CSS Driven by DokuWiki