en

Embedded module TQM6x - QNX BSP documentation

  • Overview
  • Bootloader
  • QNX Neutrino
  • Build System
  • Downloads
  • FAQ
  • How To
  • Known Issues

Overview

due to licensing restrictions this BSP is available only on request

Bootloader

u-boot Version

u-boot 2013.04

u-boot Features

Component Status Remarks
CPU + i.MX6Q / i.MX6S (Cortex A9)
Ethernet + 1 x FEC (100 MBit working, GiGE under investigation)
+ USB - Ethernet Bridge
eSDHC + SD card / eMMC
UART + one for console
I²C + EEPROM, Temperature Sensors
GPIO custum configuration on request
IIM/Fuse - on request
SPI + SPI NOR Flash
eMMC / SD boot +
TFTP boot +
TFTP boot +
SPI NOR boot +
Key: + tested | - untested | ? open

QNX Neutrino


QNX Neutrino 6.6.0

TQ Product Device Interface Function Remarks
TQMa6x i.MX6 ENET1
FLEXCAN1
FLEXCAN2
I2C1
I2C3
IPU1 Parallel LCD QNX screen graphics with Open GL ES gears demo
Touch Touch FT5x Display ETM0700G0DH6
UART2
UART3
UART4
UART5
USB_UH1
RTC DS1339
uSDHC SD(HC)-Card
Watchdog
MBa6x USB2517 USB Host


en/arm/tqma6x/qnx.txt · Last modified: 2015/03/17 11:19 by liedmann

 

Disclaimer

TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International


Recent changes RSS feed Valid XHTML 1.0 Valid CSS Driven by DokuWiki