User Tools

Site Tools


vmware.png nfs.png tftp.png subversion.png eclipse.png logo.png tutorial.png

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
en:arm:tqma7x:linux:ptxdist:known_issues [2018/06/13 13:37]
liedmann added RS485 issue
en:arm:tqma7x:linux:ptxdist:known_issues [2018/06/13 13:38] (current)
liedmann old revision restored (2018/05/22 11:17)
Line 36: Line 36:
 ---- ----
  
-===== MBa57x ​======+===== MBa7x ======
 ==== RS485 ==== ==== RS485 ====
 ^ RS485 bus block in half-duplex mode  ^^ ^ RS485 bus block in half-duplex mode  ^^
-^ Affects ​  | RS485 via UARTx on MBa57xx Revsion 01xx  ​+^ Affects ​  | RS485 via UARTx   ​
-^ Issue     | During ​AM57xx ​reset the UARTx.CTS# pin is low by default (CPU internal pull down)  | +^ Issue     | During ​i.MX7 reset the UARTx.CTS# pin is low by default (CPU internal pull down)  | 
-^ Effect ​   | Using the AM57xx ​RS485 circuitry in a half-duplex slave device or half-duplex multi-master environment may block the RS485 bus during ​AM57xx ​reset.\\ The bus is released as soon as the UARTx.CTS# pin is properly configured by software (e.g. U-Boot, Linux, etc.)  | +^ Effect ​   | Using the MBa7x RS485 circuitry in a half-duplex slave device or half-duplex multi-master environment may block the RS485 bus during ​i.MX7 reset.\\ The bus is released as soon as the UARTx.CTS# pin is properly configured by software (e.g. U-Boot, Linux, etc.)  | 
-^ Solution / Workaround ​ | Add a 10k pull up to the UARTx.CTS# signal on carrier board \\  This behaviour will be fixed with MBa57xx REV.02xx ​  |+^ Solution / Workaround ​ | Add a 10k pull up to the UARTx.CTS# signal on carrier board  |
  

en/arm/tqma7x/linux/ptxdist/known_issues.txt · Last modified: 2018/06/13 13:38 by liedmann


Disclaimer

TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.


Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Valid XHTML 1.0 Valid CSS Driven by DokuWiki