== Version 2.22 -15.06.14 ==

  * fixed eboot issue downloading Image via Enet2
  * fixed EEPROM-MAC-address
  * added WRMac as an application
  * GPIO - Pindriver

== Version 2.20 - 15.01.14 ==

  * internal / external Ethernet-Phy has settable clocks now
  * supporting eMMC above 2 GB


== Version 2.12 - 26.06.13 ==

  * support for 10 and 100 MBIT Ethernet,Hotplug support
  * fixed UpdateImg.exe - Image update out of the running operation


== Version 2.10 - 04.12.12 ==

  * patch for PMIC
  * speed up system boot
  * show splash over the whole boot process
  * supporting SDHC

== Version 2.02 - 08.07.12 ==

  * support for reading MAC addresses from EEPROM
  * EEPROM addresses 0 - 0x60 could not used for application any more (not writeable)
  * added demo application "WriteMAC"

== "WriteMAC" program process ==

  * check eboot menu point 6 for programmed MAC address in eboot
  * if MAC address is not set  -> read from EEPROM )
  * set MAC address

  * check registry for MAC addresses settings in the system image
  * if MAC is not set in registry, MAC address will be setup from eboot 

== Version 2.01 - 25.06.12 ==

  * 10 / 100 Ethernet auto negotation work (no hot plug support)
  * changed power settings in XLDR + debug messages from power register in Main() of system image 
  * configured USB Actve-Sync to predefined COM port
  * SD-2 interface could be deactivated, eMMC stays active
  * added CLICK (Buzzer)
  * version is shown in eboot
  * added CAN Stack

== Handling ==

  * source + binary - BSP as installer - package



  * binary image = test image out of the BSP binarys