==== Changelog ====

<WRAP hide>
++++2018/05/18 -REV 0118|
**U-Boot v2013.07 - TQMa335x/L**
  * Support for TQMa335x variant AB

**Linux v3.14.19 - TQMa335x/L**
  * Optimized kernel config
++++
</WRAP>


++++2017/07/07 -REV 0117|
**U-Boot v2013.07 - TQMa335x/L**
  * tqma335x: add module identification eeprom support
  * ksz9031: center flp timing
  * am33xx: Always inhibit init/refresh during DDR phy init
  * am33xx,ddr3: fix ddr3 sdram configuration
  * ARM: am437x: Enable hardware leveling for EMIF
  * ARM: AM43xx: EPOS_EVM: Add support for LPDDR2
  * ARM: AM33xx+: Update ioregs to pass different values
  * am33xx: Stop modifying certain EMIF4D registers
  * tqma335x: adapt loadaddr and fdtaddr locations
  * tqma335x: new DDR3 timing, CLKINVERT=1
  * MMC: add MMC_VERSION_5_0

**Linux v3.14.19 - TQMa335x/L**
  * mba335x: dt: adapt to etm0700g0bdh6 timing
**Linux v3.14.19 (ti2014.10) - TQMa335x:**
  * <none>
**Linux v3.14.19-rt16 - TQMa335x**
  * <new>
**Linux v4.4.39 - TQMa335x:**
  * <new>
++++


++++2016/04/18 - REV 0115|

  *Integration to ARM BSP (see also TQMa28 BSP changes)
  *Add support TQMa335xL (same as TQMa335x, except RAM timing)
  *TQMa335xL: no U-Boot build for SPI (no flash present)
  *Kernel Update 3.14.19 and ti2014.10.00

** Build tools **
  * OSELAS.Toolchain-2014.12.2

** U-Boot **
  *MMC dsr support
  *Support for multiple Ethernet PHYs  
  *Fixed reset freeze
  *Show kernellog on tty0
  *Show correct capacity for e-MMC SLC mode
  *Add MAC address for second Ethernet interface

** Linux kernel **
  *Support for MBa335x interfaces
  *Median filter for analog touch coordinates
  *Add sound support
  *Fix RTC support in PMIC
  *Fixed parallel display on mainline kernel
  *Support new standard display revision
  *Support new touch version on display kit (still buggy)
++++


++++2014/09/22 - REV 0102|

** BSP ** 
  * upgrade gdb version to 7.7.1

** Linux 3.12.10 **
  * MMC: add support for SET_DSR command
  * MMC: mmc-esdhci-imx: add DSR device tree support
  * drivers: net: phy: micrel: errata for KSZ9031
  * tqma335x: dt: usb1 as peripheral
  * am33xx: trigger cold reset to fix samsung ddr3 freeze

** U-boot 2013.07 **
  * mmc: add setdsr suppport
  * tqma335x: set dsr setting and populate to dt
  * tqma335x: register both phys
  * tqma335x: trigger cold reset to fix samsung ddr3 freeze
++++