====== MBa8MPxL DIP switch settings ====== 

===== Boot Devices =====

The following boot modes of the i.MX8MP can be selected by the DIP switch S1 on the MBa8MPxL. 
<grid>
<col sm="3">
<panel type="primary" title="SD-Card">
<WRAP centeralign>
[size=150%]**S1**[/size]
{{ :en:dip_4_1100.png?nolink&150 |}}
</WRAP>
\\
</panel>
</col>


<col sm="3">
<panel type="primary" title="eMMC">
<WRAP centeralign>
[size=150%]**S1**[/size]
{{ :en:dip_4_0100.png?nolink&150 |}}
</WRAP>
\\
</panel>
</col>

<col sm="3">
<panel type="primary" title="QSPI NOR">
<WRAP centeralign>
[size=150%]**S1**[/size]
{{ :en:dip_4_0110.png?nolink&150 |}}
</WRAP>
\\
</panel>
</col>
<col sm="3">
<panel type="primary" title="Serial Downloader">
<WRAP centeralign>
[size=150%]**S1**[/size]
{{ :en:dip_4_0001.png?nolink&150 |}}
</WRAP>
\\
</panel>
</col>
</grid>

===== Functional DIP Switches =====
DIP-Switch settings for Boot and CAN.

<grid>
<col sm="6">
<panel type="primary" title="Boot Configuration (S1)">
DIP switch S1 is used to configure the BOOT_MODE Pins.
^  DIP  ^  Signal Name  ^  OFF  ^  ON  ^
|  S1-1  |  BOOT_MODE0  |  LOW  |  HIGH  |
|  S1-2  |  BOOT_MODE1  |  LOW  |  HIGH  |
|  S1-3  |  BOOT_MODE2  |  LOW  |  HIGH  |
|  S1-4  |  BOOT_MODE3  |  LOW  |  HIGH  |
</panel>
</col>

<col sm="6">
<panel type="primary" title="CAN1 configuration (S10)">
DIP switch S10 is used to configure the CAN interfaces CAN1.
^  Funktion  ^  S10-1  ^  S10-2  ^
|  CAN-Bus not terminated  |  OFF  |  OFF  |
|  not defined (illegal state)  |  OFF  |  ON  |
|  not defined (illegal state)  |  ON  |  OFF  |
|  CAN-Bus terminated with 120 Ohm  |  ON  |  ON  |
</panel>
</col>

</grid>

<grid>
<col sm="6">
<panel type="primary" title="CAN2 configuration (S11)">
DIP switch S11 is used to configure the CAN interfaces CAN2.
^  Funktion  ^  S11-1  ^  S11-2  ^
|  CAN-Bus not terminated  |  OFF  |  OFF  |
|  not defined (illegal state)  |  OFF  |  ON  |
|  not defined (illegal state)  |  ON  |  OFF  |
|  CAN-Bus terminated with 120 Ohm  |  ON  |  ON  |
</panel>
</col>

</grid>