WORK IN PROGRESS Embedded module en tqmls10xxA TQMLS10xxA layerscape linux openwrt OpenWrt Linux \\ \\ ===== Preface ===== The instructions on this page have been tested on Ubuntu 18.04 (64 bit) in a VMWare virtual machine. The instructions on this page refer to the BSP and ancillary tools listed in the following table: ^ BSP Revision ^ [[https://github.com/tq-systems/openwrt/tree/OpenWrt.TQMLS10xx.BSP.SW.0001|0001]] ^ ^ OpenWrt Release | [[https://git.openwrt.org/?p=openwrt/openwrt.git;a=commit;h=fcd14017007db35a4a41ef4fd6b69a5e02edbd5e|Master branch]] | ^ Target Devices | tqmls1043a-mbls10xxa\\ tqmls1043a-mbls10xxa-2g\\ tqmls1046a-mbls10xxa\\ tqmls1046a-mbls10xxa-8g\\ | ^ U-Boot | [[https://github.com/tq-systems/u-boot-tqmaxx/tree/TQMLS10xxA-u-boot-v2018.07|2018.07 + TQ patches]] | ^ Linux | 4.19.108 Mainline + [[https://github.com/tq-systems/openwrt/tree/TQMLS10xxA/target/linux/generic|OpenWrt patches]] + [[https://github.com/tq-systems/openwrt/tree/TQMLS10xxA/target/linux/tqmls/patches-4.19|TQ patches]] | ===== Prerequisites ===== The distribution of your choice, however, may not have installed all required packages by default. Commonly missing packages (package names taken from Debian based systems) include: sudo apt-get install subversion g++ zlib1g-dev build-essential git python python3 python3-distutils libncurses5-dev gawk gettext unzip file libssl-dev wget libelf-dev ecj fastjar java-propose-classpath python unzip ===== BSP build ===== It's strongly recommended to use **git** for downloading both the Yocto Project / Poky Release as well as ci-meta-tq (instead of downloading archives and extracting them). 1. Create a local copy of the OpenWrt repository git clone -b TQMLS10xxA https://github.com/tq-systems/openwrt.git 2. Checkout BSP release on new local branch. cd openwrt git checkout OpenWrt.TQMLS10xx.BSP.SW.0001 -b openwrt-tqmls10xxa 3. Setup local branch to track the remote branch. git branch -u TQMLS10xxA 4. Configure the Build cp ci/tqmls10xx_defconfig .config 5. Build an Image for STKLS10xxA make world 6. Write the Image to SD Card\\ the resulting SD Card image is openwrt/bin/targets/tqmls/tqmls10xxa/openwrt-tqmls-tqmls10xxa-tqmls1046a-mbls10xxa-ext4-firmware_sdcard.img sudo dd if=openwrt/bin/targets/tqmls/tqmls10xxa/openwrt-tqmls-tqmls10xxa-tqmls1046a-mbls10xxa-ext4-firmware_sdcard.img of=TARGET_DEVICE 8. Boot the STKLS10xxA from SD card Please see the [[en:arm:tqmls10xxa:starterkit|DIP Switch Settings]] how to setup the Starterkit to boot from SD Card.