====== Install an OS image using the TQ-SD Card ====== 
<WRAP round tip>From now (March 2012) on, all starterkits will include an TQ SD card, which allows installing either Linux or Windows onto the onboard eMMC flash.</WRAP>

====== Preparations ======
   - Insert TQ SD card into SD slot.
  - Set DIP switches to "Boot from SD card":\\ {{page>en:tqma28:dip_switches#boot_from_sd_card&noheader}}
  - Supply power.
  - A preinstalled Linux boots from the SD card.

====== Installation of an OS image ======
The installation tool  starts automatically and (using the serial console) displays the following menu:
<code>
#===========================================#
# TQ Embedded Operating System Installation #
#===========================================#
U-Boot configuration found
Which Operating System?
1) Linux
2) Windows
3) Exit
Type Number:
</code>
Entering a number will start the installation of the corresponding OS image and show its progress.
<WRAP round info>Choosing ''Exit'' drops to a bash shell, no modifications are made to the system in this case.</WRAP>
Once the installation is finished the message "Press any key to restart" is displayed.

====== Restarting the system ======
<WRAP round important>Prior to restarting the system the DIP switches have to be set to "Boot from eMMC":\\ {{page>en:tqma28:dip_switches#boot_from_emmc&noheader}}</WRAP>
The SD card can be removed after shutdown.

====== Configuring eboot ======
<WRAP round important>Only required if Windows CE has been installed</WRAP>

Pressing the space key at the eboot prompt will interrupt the boot process and display eboot's configuration menu.\\
For Windows CE to boot properly the options
  * ''[5] Select Boot Device''
  * ''[K] KITL Enable Mode''
have to be set up as follows:
<code>
Press [ENTER] to download now or [SPACE] to cancel.

Initiating image download in 1 seconds.
-----------------------------------------------------------------------------
Freescale iMX SOC Menu Item
-----------------------------------------------------------------------------
 [0] IP Address : 192.168.111.10
 [1] Set IP Mask : 255.255.255.0
 [2] Boot Delay : 3
 [3] DHCP : Enabled
 [4] Reset to Factory Default Configuration
 [5] Select Boot Device : NK from SD/MMC
 [6] Set MAC Address : 0-2-B3-92-A8-C4
 [7] Hive based registry : Load form filesys
 [9] Bootloader Shell
 [I] KITL Work Mode : Interrupt
 [K] KITL Enable Mode : Disable
 [P] KITL Passive Mode : Disable
 [S] Save Settings
 [D] Download Image Now
 [L] Launch Existing Flash Resident Image Now
 [E] Select Ether Device : ENET
 [M] MMC and SD Utilities
 [U] Set UUID : 0-0-0-0-0-0-0-0-0-0-0-0-0-0-0-0

 Selection:

</code>