====== Configuring U-Boot ======
===== Default settings =====

| IP-Address  | 172.16.135.170  |
| Netmask  | 255.255.255.0   |
| Default-Gateway  | 172.16.135.254  |
| MAC-Address | 02:00:01:00:00:01 |
| IP-Mode Kernel  | static  |
| LC-Display  | FG0700K5DSSWBG01 |
| root password  | root  |

The TCP/IP parameters can be changed in U-Boot. Therefore a serial connection to the MBa28 board is required. Interrupt the boot process by pressing any key. Set new values for the corresponding variables and save the environment:

<code bash>
setenv ipmode static
setenv ipaddr 1.2.3.4
setenv netmask 255.255.255.0
setenv gatewayip 1.2.3.254
setenv ethaddr 02:00:01:00:23:44
saveenv
boot</code>

{{:sys:mfg06.png|}}

If ''ipmode'' is set and contains the value ''static'', the IP parameters (IP address, gateway, etc.) will be passed to the kernel as a static configuration. If it contains the value ''dyn'', the kernel will configure the first interface using DHCP.

The ethernet MAC address of the second interface (''eth1addr'') is derived from that of the first interface (''ethaddr'') by incrementing the last byte. Therefore the default is ''02:00:01:00:00:02''.

U-Boot itself uses the static configuration by default, e.g. for downloading a kernel image via TFTP.

===== Configuring display =====

Currently several LC displays are supported. Just set the U-Boot variable ''lcdpanel'' according to the display:
^ value of ''lcdpanel'' ^ Display ^
| fg0700 (default) | FG0700K5DSSWBG01 |
| etv570g2dmu | ETV570G2DMU |
| etq570g0dh6 | ETQ570G0DH6 |
| et0350g0dh6 | ET0350G0DH6 |
| (none) | no display |

<code bash>
setenv lcdpanel etq570g0dh6
</code>