en:arm:tqma28:windows:changelog

Table of Contents

Version 2.22 -15.06.14
Version 2.20 - 15.01.14
Version 2.12 - 26.06.13
Version 2.10 - 04.12.12
Version 2.02 - 08.07.12
"WriteMAC" program process
Version 2.01 - 25.06.12
Handling

Version 2.22 -15.06.14

fixed eboot issue downloading Image via Enet2
fixed EEPROM-MAC-address
added WRMac as an application
GPIO - Pindriver

Version 2.20 - 15.01.14

internal / external Ethernet-Phy has settable clocks now
supporting eMMC above 2 GB

Version 2.12 - 26.06.13

support for 10 and 100 MBIT Ethernet,Hotplug support
fixed UpdateImg.exe - Image update out of the running operation

Version 2.10 - 04.12.12

patch for PMIC
speed up system boot
show splash over the whole boot process
supporting SDHC

Version 2.02 - 08.07.12

support for reading MAC addresses from EEPROM
EEPROM addresses 0 - 0x60 could not used for application any more (not writeable)
added demo application “WriteMAC”

"WriteMAC" program process

check eboot menu point 6 for programmed MAC address in eboot
if MAC address is not set → read from EEPROM )
set MAC address

check registry for MAC addresses settings in the system image
if MAC is not set in registry, MAC address will be setup from eboot

Version 2.01 - 25.06.12

10 / 100 Ethernet auto negotation work (no hot plug support)
changed power settings in XLDR + debug messages from power register in Main() of system image
configured USB Actve-Sync to predefined COM port
SD-2 interface could be deactivated, eMMC stays active
added CLICK (Buzzer)
version is shown in eboot
added CAN Stack

Handling

source + binary - BSP as installer - package

binary image = test image out of the BSP binarys