Table of Contents

Operating System

Version

Windows CE 6.0

Features

Components Status Comments
Boot + from eMMC and SD-Card
Ethernet +
eMMC +
ext. SD +
Display + FG0700K5DSSWBG01
CLAA070LC0ACW
ET0350G0DH6
Touch +
USB + HID and Masstorage
Sound +
EEPROM +
CAN +
DUART +
GPIO +
AUART0 +
AUART1 +
AUART2 + not connected
AUART3 +
AUART4 +
Akku/Goldcap -
Buzzer +
Key: + tested | - untested | ? open

Changelog


  • fixed eboot issue downloading Image via Enet2
  • fixed EEPROM-MAC-address
  • added WRMac as an application
  • GPIO - Pindriver

Version 2.20 - 15.01.14

  • internal / external Ethernet-Phy has settable clocks now
  • supporting eMMC above 2 GB

Version 2.12 - 26.06.13

  • support for 10 and 100 MBIT Ethernet,Hotplug support
  • fixed UpdateImg.exe - Image update out of the running operation

Version 2.10 - 04.12.12

  • patch for PMIC
  • speed up system boot
  • show splash over the whole boot process
  • supporting SDHC

Version 2.02 - 08.07.12

  • support for reading MAC addresses from EEPROM
  • EEPROM addresses 0 - 0x60 could not used for application any more (not writeable)
  • added demo application “WriteMAC”

"WriteMAC" program process

  • check eboot menu point 6 for programmed MAC address in eboot
  • if MAC address is not set → read from EEPROM )
  • set MAC address
  • check registry for MAC addresses settings in the system image
  • if MAC is not set in registry, MAC address will be setup from eboot

Version 2.01 - 25.06.12

  • 10 / 100 Ethernet auto negotation work (no hot plug support)
  • changed power settings in XLDR + debug messages from power register in Main() of system image
  • configured USB Actve-Sync to predefined COM port
  • SD-2 interface could be deactivated, eMMC stays active
  • added CLICK (Buzzer)
  • version is shown in eboot
  • added CAN Stack

Handling

  • source + binary - BSP as installer - package
  • binary image = test image out of the BSP binarys