1. Download the target configuration file for LS1012A and save it as “ls1012a.cfg” on a SD Card prepared with a FAT32 filesystem.
2. Plug in the SD Card into the PEEDI programmer.
3. Start the terminal emulator and establish a new connection to the COM port where the PEEDI is connected to the host. Setup the serial connection as follows:
Baudrate | 115200 |
---|---|
Data | 8 |
Parity | N |
Stop bits | 1 |
4. Type card dir to list the content of the SD card
5. Type transfer card:ls1012a.cfg eep:ls1012a.cfg to copy the config file to the EEPROM
6. Press and hold RESET button, then press both front panel buttons to restart and enter RedBoot command line.
7. Type fconfig to set up the network connection as follows:
DHCP | no |
---|---|
Gateway | IP 10.250.250.1 |
Local IP | 10.250.250.2 |
Local IP mask | 255.255.255.0 |
Default TFTP IP | 10.250.250.1 |
Target configuration file path | ://ls1012a.cfg |
DNS IP | leave blank |
Proxy | no |
Firmware update path | 1 |
8. Type y to save the new settings
9. Press the RESET button on the PEEDI programmer.
flash program tftp://10.250.250.1/u-boot-pbl-512mb-qspi-sd.bin 0x0 erase flash program tftp://10.250.250.1/ppa-tqmls1012al-mbls1012al.itb bin 0x00400000 erase flash program tftp://10.250.250.1/pfe_fw_sbl.itb bin 0x00A00000 erase
flash program tftp://10.250.250.1/bl2_qspi.pbl bin 0x0 erase flash program tftp://10.250.250.1/fip_uboot.bin bin 0x00100000 erase flash program tftp://10.250.250.1/pfe_fw_sbl.itb bin 0x00A00000 erase