Known Issues scarthgap.TQ.ARM.BSP.0006
- TQMLS1088A: software
reset or reboot always boots from QSPI when the flash
contains a valid boot image.
- TQMLS1088A: Suspend to RAM not supported.
- SMMU bypass is required
- MBLS10xxA: Interrupt of GPIO expander
D57 (IRQ2) is permanently asserted
because CLKO from CAN controller (D60) generates continuously interrupts
on input of GPIO expander
- There is no support for masking interrupts on the GPIO expander
- This also affects the shared interrupts of
D58 and D59 GPIO expander
- Therefore the IRQ of GPIO expander is unsed
- CAN-FD controller (D60) is not accessible using SPI
- USB 3.0 Type-C (X16) is host-only
- RS-485 (X23):
linux,rs485-enabled-at-boot-time property must not be set
- In BSP, suspend to disk is not supported, despite CONFIG_HIBERNATION being
compiled into the kernel.