To activate or deactivate eMMC Support apply the following settings:
1. Boot the system into the BIOS menu
2. Set up 'SCS/SCC Configuration' option in the BIOS Menu accordingly:
BIOS Frontpage > Setup Utility > Advanced (Tab) > RC Advanced Menu > PCH-IO Configuration > SCS Configuration > eMMC 5.1 Controller = <Enabled>
3. Press <F10> to save the settings and reboot the system
There are several ways to reset the UEFI firmware settings to the default values.
The UEFI settings can be reset by pressing F9 in the UEFI. You have to be in the Setup Utility Page to use this function.
To reset the settings without the display, proceed as follows:
When updating the UEFI firmware, the firmware defaults are loaded and all changes to the settings are lost.
Installing the same firmware resets these settings (e.g. UEFI update under Windows).
Our modules provide a function that allows to reset the UEFI to default values in case of emergency.
For this, the reset button must be pressed three times within one second.
If the module LED blinks red for a short time the reset to defaults was successful.
To activate Console Recirection in the BIOS via the serial port in addition to the display output on the Starterkit apply the following steps.
It can be useful for BIOS remote control tasks.
Bautrate: | 115200 |
---|---|
Data bits: | 8 |
Parity: | none |
Stop bits: | 1 |
Handshake : | XON/XOFF |
⇒ Reboot the Starterkit and use the terminal emulator to set up the BIOS
This guide provides step-by-step instructions on how to install the Ubuntu operating system on the TQMx110EB Embedded Module, which is based on an Intel x86 CPU.
Prerequisites
Download the latest version of Ubuntu for x86 systems:
Click here to download Ubuntu 22.04.3 LTS
Write the downloaded Ubuntu ISO to an SD card or USB stick using an image writer tool. We recommend using Balena Etcher:
Click here to download Balena Etcher
After the installation is complete and you've restarted into your new Ubuntu system:
sudo apt update sudo apt upgrade
Ubuntu should now be successfully installed on your TQMx110EB Embedded Module.
This guide provides step-by-step instructions on how to install Windows 10 IoT Enterprise on the TQMx110EB Embedded Module, which is based on an Intel x86 CPU.
Prerequisites
Download the latest version of Windows 10 IoT Enterprise for x86 systems:
Information about the latest Windows 10 IoT Enterprise
Write the downloaded Windows 10 IoT Enterprise image to an SD card or USB stick using a tool like Rufus:
After the installation is complete and you've booted into Windows 10 IoT Enterprise:
Windows 10 IoT Enterprise should now be successfully installed on your TQMx110EB Embedded Module.