Set Timeout to 0 seconds
Correct Board ID String
Do not show Dual or Legacy Boot Type option
Reduce SD card speed
Adapt setup menu (hide some options)
Change Default configuration
PSE Configuration
SerialIo Configuration
I2C0 Controller <Disabled>
I2C2 Controller <Disabled>
I2C3 Controller <Disabled>
I2C4 Controller <Disabled>
I2C6 Controller <Disabled>
I2C7 Controller <Disabled>
UART0 Controller <Disabled>
UART1 Controller <Disabled>
Other
eMMC 5.1 HS400 Mode <Disabled>
HID Event Filter Driver <Disabled>
REFRESH_2X_MODE <Enabled for WARM or HOT>
eMMC 5.1 Controller <Disabled>
SDCard 3.0 Controller <Disabled>
C states <Disabled>
eMMC 5.1 HS400 Mode <Enabled>
Enable HS400 software tuning <Enabled>
Audio Link Mode <Advanced Link Config>
DMIC #0 [ ]
DMIC #1 [ ]
SNDW #1 [ ]
Additional Serial IO devices [X]
HSUART1/RS485 <None>
UART2 <Host owned with pin muxed>
HSUART2/RS485 <Host owned with pin muxed>
Do not restore defaults after CMOS lost
Fix not working 4GB memory variant
Hide DDR50 eMMC mode
Correct memory SPD data (adapt to Intel recommended)
Fix not working Ethernet
Set Ethernet GPIOs, gpio muxing and variable defaults same as CRB
Set CPLD UARTs to fix address and IRQ configuration
Set USB3 speed capability to Gen1
Enable UFSx2 to fix Power State issue
Disable Console Redirection
Fix missmatch message in PSE SCU
add eMMC driver 1930
Set Power Strap VVV SFR_OG_PG to YES
SioF81214E: Fix not shown COMs in Win10
SioF81214E: Fix not working COMB
SioF81214E: Set ASL Device Name Prefix
SioF81214E: Change Default base address and IRQ configuration
SioF81214E: Fix not shown SSDT table in Windows (RWE)
SioF81214E: Configure some PCDs
SioF81214E: Enable package
SioF81214E: Add package
SioTqmx86: Hide LVDS feature when LVDS bridge is not populated
SioTqmx86: Add LVDS Clock Spreading menu
SioTqmx86: Enable Package
SioTqmx86: Add Package from earlier commit
Configure Board configuration via DEFINES
Configure SerIRQ in eSPI-to-LPC bridge ECE1200
use OemSvcLoadDefaultSetupMenu for 3 x reset processing
Set Memory SPD data dependend on board GPIOs
Set GPIO config in OEM Services
Disable I2S Codec Select
Delete batch file to prevent notice after build
Fix HDA not working (plus line-in used on
MB-COME10-2)
Add verb table for ALC262 codec
Disable some Super IOs not used
Integrate TQ Boot Logo
Set maximal password length to 20 letters
Change InsydeH2O Version shown in SCU
Define BoardID as no Intel CRB
Reduce ID Read and Write/Erase frequency of SPI
Adapt CSE Configuration
Add SPI Flashes in VSCC entries
Correct Power Straps in Fit
Adapt eSPI frequencies and set IO-Modes to single
Adapt GPIO voltages
Define DQS Map CPU to DRAM mapping
Add gitignore file