Overview
BSP / Hardware compatibility
The Windows CE BSP only compatible to TQMa28 Module Revision ≤ 0202
Current versions & features
Eboot
Features
| Component | Status | Remarks |
|---|---|---|
| CPU | + | |
| Ethernet | + | |
| Key: + tested | - untested | ? open | ||
Windows CE 6.0
Features
| Components | Status | Comments |
|---|---|---|
| Boot | + | from eMMC and SD-Card |
| Ethernet | + | |
| eMMC | + | |
| ext. SD | + | |
| Display | + | FG0700K5DSSWBG01 |
| CLAA070LC0ACW | ||
| ET0350G0DH6 | ||
| Touch | + | |
| USB | + | HID and Masstorage |
| Sound | + | |
| EEPROM | + | |
| CAN | + | |
| DUART | + | |
| GPIO | + | |
| AUART0 | + | |
| AUART1 | + | |
| AUART2 | + | not connected |
| AUART3 | + | |
| AUART4 | + | |
| Akku/Goldcap | - | |
| Buzzer | + | |
| Key: + tested | - untested | ? open | ||
Changelog
Version 2.22 -15.06.14
- fixed eboot issue downloading Image via Enet2
- fixed EEPROM-MAC-address
- added WRMac as an application
- GPIO - Pindriver
Version 2.20 - 15.01.14
- internal / external Ethernet-Phy has settable clocks now
- supporting eMMC above 2 GB
Version 2.12 - 26.06.13
- support for 10 and 100 MBIT Ethernet,Hotplug support
- fixed UpdateImg.exe - Image update out of the running operation
Version 2.10 - 04.12.12
- patch for PMIC
- speed up system boot
- show splash over the whole boot process
- supporting SDHC
Version 2.02 - 08.07.12
- support for reading MAC addresses from EEPROM
- EEPROM addresses 0 - 0x60 could not used for application any more (not writeable)
- added demo application “WriteMAC”
"WriteMAC" program process
- check eboot menu point 6 for programmed MAC address in eboot
- if MAC address is not set → read from EEPROM )
- set MAC address
- check registry for MAC addresses settings in the system image
- if MAC is not set in registry, MAC address will be setup from eboot
Version 2.01 - 25.06.12
- 10 / 100 Ethernet auto negotation work (no hot plug support)
- changed power settings in XLDR + debug messages from power register in Main() of system image
- configured USB Actve-Sync to predefined COM port
- SD-2 interface could be deactivated, eMMC stays active
- added CLICK (Buzzer)
- version is shown in eboot
- added CAN Stack
Handling
- source + binary - BSP as installer - package
- binary image = test image out of the BSP binarys