Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:arm:tqma53:linux:how_to [2017/08/25 14:32] – schmid | en:arm:tqma53:linux:ptxdist:how_to [2022/08/04 15:02] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOCACHE~~ | ~~NOCACHE~~ | ||
- | <embed en: | + | <embed en: |
<label lang> | <label lang> | ||
<label mod_name> | <label mod_name> | ||
Line 7: | Line 7: | ||
<label bsp_name> | <label bsp_name> | ||
<label bsp_name_head> | <label bsp_name_head> | ||
+ | <label build_system> | ||
+ | <label build_system_head> | ||
+ | <label product_type> | ||
</ | </ | ||
\\ | \\ | ||
Line 154: | Line 157: | ||
**For BSP rev. 0104** | **For BSP rev. 0104** | ||
- | Follow the instructions under [[en: | + | Follow the instructions under [[en: |
**For BSP rev. 0105** | **For BSP rev. 0105** | ||
Line 266: | Line 269: | ||
** BSP rev 0105:** Samples for device tree are in the BSP under {BSPROOT}/ | ** BSP rev 0105:** Samples for device tree are in the BSP under {BSPROOT}/ | ||
- | see [[en: | + | see [[en: |
==== Configure DVI / parallel display ==== | ==== Configure DVI / parallel display ==== | ||
Line 428: | Line 431: | ||
**TQMa53 Hardware rev. 0300** | **TQMa53 Hardware rev. 0300** | ||
- | Works out of the Box with BSP 0105. Support for older BSP on Request. | + | Works out of the Box with BSP Revision ≥ 0105. Support for older BSP on Request.\\ |
+ | Please have a look at our **[[intern: | ||
**TQMa53 Hardware rev. 0200** | **TQMa53 Hardware rev. 0200** | ||
Line 505: | Line 510: | ||
* Build | * Build | ||
+ | ===== u-boot ===== | ||
+ | |||
+ | ==== Reset source handling ==== | ||
+ | The i.MX53 System Reset Controller provides information about reset sources in the SRSR register. Mainline u-boot as of v2013.01 reads this register and resets information after reading to enable clean info at next boot. Decoding is done for single reset sources only. If your baseboard contains an supervisor which is connected to the reset input of the i.MX53 two reset sources (POR and IPP USER) are detected but not decoded - the reset source is reportes an " |