Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:arm:tqma53:linux:ptxdist:how_to [2018/05/24 11:13] – ↷ Links angepasst weil Seiten im Wiki verschoben wurden liedmann | en:arm:tqma53:linux:ptxdist:how_to [2022/08/04 15:02] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOCACHE~~ | ~~NOCACHE~~ | ||
- | <embed en: | + | <embed en: |
<label lang> | <label lang> | ||
<label mod_name> | <label mod_name> | ||
Line 7: | Line 7: | ||
<label bsp_name> | <label bsp_name> | ||
<label bsp_name_head> | <label bsp_name_head> | ||
+ | <label build_system> | ||
+ | <label build_system_head> | ||
+ | <label product_type> | ||
</ | </ | ||
\\ | \\ | ||
Line 507: | Line 510: | ||
* Build | * Build | ||
+ | ===== u-boot ===== | ||
+ | ==== Reset source handling ==== | ||
+ | |||
+ | The i.MX53 System Reset Controller provides information about reset sources in the SRSR register. Mainline u-boot as of v2013.01 reads this register and resets information after reading to enable clean info at next boot. Decoding is done for single reset sources only. If your baseboard contains an supervisor which is connected to the reset input of the i.MX53 two reset sources (POR and IPP USER) are detected but not decoded - the reset source is reportes an " |