MBa8Xx DIP switch settings
Boot Modes
The following boot modes of the i.MX8X can be selected by the DIP switch S1 on the MBa8Xx.
SD-Card
S1
eMMC
S1
QSPI NOR
S1
Serial Downloader
S1
Boot from Fuses
S1
Functional DIP Switches
DIP-Switch settings for DP-Bridge and CAN.
DSI-to-DP-Bridge (S9)
Only available on MBa8Xx Rev.01xx
| DIP | S9 |
|---|---|
| ON | enable DSI-to-DP-Bridge |
| OFF | use LVDS interface |
CAN configuration
DIP switch SW1 is used to configure CAN0.
| Function | SW1-1 | SW1-2 |
|---|---|---|
| CAN-Bus not terminated | OFF | OFF |
| not defined (illegal state) | OFF | ON |
| not defined (illegal state) | ON | OFF |
| CAN-Bus terminated with 120 Ohm | ON | ON |
DIP switch SW2 is used to configure CAN1.
| Function | SW2-1 | SW2-2 |
|---|---|---|
| CAN-Bus not terminated | OFF | OFF |
| not defined (illegal state) | OFF | ON |
| not defined (illegal state) | ON | OFF |
| CAN-Bus terminated with 120 Ohm | ON | ON |