This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ~~NOCACHE~~ <embed en:templates:tabs_qnx> <label lang>en</label> <label mod_name>tqmls102xa</label> <label mod_name_head>TQMLS102xA</label> <label mod_arch>arm</label> <label bsp_name>qnx</label> <label bsp_name_head>QNX Neutrino</label> </embed> \\ \\ ===== Overview ===== <WRAP round important>Due to licensing restrictions this BSP is available only on request </WRAP> ===== Bootloader ===== ===== Bootloader ===== ==== Supported features ==== ^ Feature ^^^^ Remarks ^ ^ TQ Product ^ Chip ^ Interface ^ Function ^ ::: ^ | TQMLS102xA | LS102xA | eSDHC | eMMC / SD-Card | Mutually exclusive (cf user's manual) | | TQMLS102xA | LS102xA | ETSEC | RGMII / SGMII | For SGMII MBLS102xA Rev. ≥ 0200 required | | TQMLS102xA | LS102xA | I2C0 | EEPROM / PMC \\ (System Reset Request) | | | TQMLS102xA | LS102xA | QSPI | QSPI NOR Flash | Up to 2 Devices | | TQMLS102xA | LS102xA | SATA | SSD/HDD | | | TQMLS102xA | LS102xA | UART1 | RS232 | Default console | | TQMLS102xA | LS102xA | USB XHCI | USB 3.0/2.0 | USB Storage Device | \\ ==== Supported boot devices ==== ^ Boot device ^ supported ^ | eMMC / SD boot | • | | SPI NOR boot | • | ==== QNX Neutrino ==== \\ **QNX Neutrino 6.6.0** \\ ^ TQ Product ^ Device ^ Interface ^ Function ^ Remarks ^ | TQMLS102xA | Ls102x | CAN1 | CAN 2.0 B | |::: |::: | CAN2 | CAN 2.0 B | |::: |::: | eTSEC0 | RGMII (10/100/1000 Mbit/s) | |::: |::: | eTSEC1 | SGMII (10/100/1000 Mbit/s) | dhcp activated (telnet user:root , with on password) | |::: |::: | eTSEC2 | RGMII (10/100/1000 Mbit/s) | |::: |::: | I2C1 | Bus Access | |::: |::: | QSPI | QSPI NOR Flash | |::: |::: | SATA | Serial ATA Revision 3.0 | |::: |::: | SPI1 | |::: |::: | uSDHC | SD(HC)-Card | |::: |::: | Watchdog | | |::: | PCF85063 | I2C1 | RTC | |MBLS102xA | SP3222E | UART1 | RS232 | Console UART | |::: | SP491E | LPUART1 | RS485 | | Last modified: 2022/08/04 15:02