WORK IN PROGRESS
Embedded module TQMLS10xxA - OpenWrt Linux BSP documentation
Preface
The instructions on this page have been tested on Ubuntu 18.04 (64 bit) in a VMWare virtual machine.
The instructions on this page refer to the BSP and ancillary tools listed in the following table:
| BSP Revision | 0001 |
|---|---|
| OpenWrt Release | Master branch |
| Target Devices | tqmls1043a-mbls10xxa tqmls1043a-mbls10xxa-2g tqmls1046a-mbls10xxa tqmls1046a-mbls10xxa-8g |
| U-Boot | 2018.07 + TQ patches |
| Linux | 4.19.108 Mainline + OpenWrt patches + TQ patches |
Prerequisites
The distribution of your choice, however, may not have installed all required packages by default. Commonly missing packages (package names taken from Debian based systems) include:
sudo apt-get install subversion g++ zlib1g-dev build-essential git python python3 python3-distutils libncurses5-dev gawk gettext unzip file libssl-dev wget libelf-dev ecj fastjar java-propose-classpath python unzip
BSP build
It's strongly recommended to use git for downloading both the Yocto Project / Poky Release as well as ci-meta-tq (instead of downloading archives and extracting them).
1. Create a local copy of the OpenWrt repository
git clone -b TQMLS10xxA https://github.com/tq-systems/openwrt.git
2. Checkout BSP release on new local branch.
cd openwrt git checkout OpenWrt.TQMLS10xx.BSP.SW.0001 -b openwrt-tqmls10xxa
3. Setup local branch to track the remote branch.
git branch -u TQMLS10xxA
4. Configure the Build
cp ci/tqmls10xx_defconfig .config
5. Build an Image for STKLS10xxA
make world
6. Write the Image to SD Card
the resulting SD Card image is openwrt/bin/targets/tqmls/tqmls10xxa/openwrt-tqmls-tqmls10xxa-tqmls1046a-mbls10xxa-ext4-firmware_sdcard.img
sudo dd if=openwrt/bin/targets/tqmls/tqmls10xxa/openwrt-tqmls-tqmls10xxa-tqmls1046a-mbls10xxa-ext4-firmware_sdcard.img of=TARGET_DEVICE
8. Boot the STKLS10xxA from SD card
Please see the DIP Switch Settings how to setup the Starterkit to boot from SD Card.