User Tools

Site Tools

vmware.png nfs.png tftp.png subversion.png eclipse.png logo.png tutorial.png

This is an old revision of the document!

Embedded module TQMT10xx - YOCTO Linux BSP documentation

The instructions on this page have been tested on Ubuntu 16.04 64bit) in a VMWare virtual machine.

The meta-tq-powerach layer extends the Yocto Project's reference system Poky to provide support for the TQMT10xx TQ Embedded CPU Modules.

The instructions on this page refer to the BSP and ancillary tools listed in the following table:

BSP Revision 0100
meta-tq-powerarch jethro-tqmtxxxx
Yocto Project / Poky Release Jethro - 2.0.1
Target machine1) tqmt1040-64b-stk
U-Boot 2015.07
Linux Kernel 4.4

It's strongly recommended to use git for downloading both the Yocto Project / Poky Release as well as meta-tq (instead of downloading archives and extracting them).

The goal of these wiki pages is to get you started using meta-tq-powerach with the STKT104x, so instead of reinventing the wheel we will adhere to the very compact Yocto Project Quick Start and supply details specific to the STKT104x where necessary.

For further details regarding Yocto Project 2.0.1 - Rocko please refer to its official documentation.


Yocto Project / Poky requires a Linux build host, so first of all you need a development workstation (or a virtual machine2)) with a (preferably) recent Linux distribution installed.

Please refer to section The Linux Distribution of the Yocto Project Quick Start for supported linux distributions and section The Build Host Packages for required build host packages for those distributions.

Although not required by Yocto Project / Poky, we also recommend to configure and run a tftp server (for image download / update) and an nfs server (for network mounted root filesystem) on your development host.

Yocto Project / Poky set-up

The Yocto Project Quick Start document explains how to set up Yocto Project / Poky and how to build images using the meta-intel layer. Using this as a guideline, the following table describes how to use the meta-tq-powerach layer for the STK104x.

Install the repo tool on development host

Initialize the repository

  • Create an empty directory: mkdir yocto && cd yocto
  • Initialize the repository: repo init -u ssh:git@github.com/tq-systems/yocto-manifest.git -b jethro-tqmtxxxx * Fetch all the source codes: repo sync Setup the Yocto project build environment
i.e. value for MACHINE variable
for testing purposes Yocto Project provides a ready to use virtual machine called Build Appliance

en/power/tqmt10xx/linux/yocto/quickstart_yocto.1568221588.txt.gz · Last modified: 2019/09/11 19:06 by liedmann


TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Valid XHTML 1.0 Valid CSS Driven by DokuWiki