This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision |
en:x86:tqmxe38m:how_to [2018/10/29 12:57] – added Hardware Monitor FAN scaling & Console Redirection bujupib | en:x86:tqmxe38m:how_to [2020/07/15 14:43] – Externe Bearbeitung 127.0.0.1 |
---|
</embed> | </embed> |
\\ | \\ |
\\ | <embed en:templates:bios_how_to> |
===== Boot from external BIOS ===== | <label lang>en</label> |
{{section>.:data#boot_from_external_bios&noheader}} | <label bios_setup_path_for_usb>**Setup Utility > Advanced > USB Configuration**</label> |
===== Console Redirection ===== | <label bios_setup_path_for_emmc>**Setup Utility > Advanced > LPSS & SCC Configuration > SCC eMMC Boot Controller**</label> |
{{section>.:..:bios_general#console_redirection&noheader}} | <label bios_setup_path_for_console>**Setup Utility > Advanced > Console Redirection > Enabled**</label> |
===== Hardware Monitor Fan Scaling ===== | <label bios_setup_path_for_hw_monitor>**Setup Utility > Advanced > SIO Hardware Monitor Nuvoton NCT7802Y > Enable Fan Scaling**</label> |
{{section>.:..:bios_general#hardware_monitor_fan_scaling&noheader}} | <label bios_setup_path_for_cpu_cores>**Setup Utility > Power > Advanced CPU Control > Active Processor Cores**</label> |
| <label bios_setup_path_for_g3>**Setup Utility > Advanced > Miscellaneous Configuration > State After G3**</label> |
| </embed> |