Differences

This shows you the differences between two versions of the page.

--- en:x86:tqmxe38m:how_to [2018/10/30 13:04] – added State after G3 & CPU core on/off bujupib
+++ en:x86:tqmxe38m:how_to [2020/08/04 14:56] – changed tab template liedmann
@@ Line 1: / Line 1: @@
 ~~NOCACHE~~
-<embed en:templates:tabs_x86>
+<embed en:templates:tabs_x86_bootstrap>
   <label mod_arch>x86</label>
   <label product_type>Embedded module</label>
@@ Line 8: / Line 8: @@
 </embed>
 \\
-\\
+<embed en:templates:bios_how_to>
-===== Boot from external BIOS  =====
+  <label lang>en</label>
-{{section>.:data#boot_from_external_bios&noheader}}
+  <label bios_setup_path_for_usb>**Setup Utility > Advanced > USB Configuration**</label>
-===== Console Redirection  =====
+  <label bios_setup_path_for_emmc>**Setup Utility > Advanced > LPSS & SCC Configuration > SCC eMMC Boot Controller**</label>
-{{section>.:..:bios_general#console_redirection&noheader}}
+  <label bios_setup_path_for_console>**Setup Utility > Advanced > Console Redirection > Enabled**</label>
-===== Hardware Monitor Fan Scaling  =====
+  <label bios_setup_path_for_hw_monitor>**Setup Utility > Advanced > SIO Hardware Monitor Nuvoton NCT7802Y > Enable Fan Scaling**</label>
-{{section>.:..:bios_general#hardware_monitor_fan_scaling&noheader}}
+  <label bios_setup_path_for_cpu_cores>**Setup Utility > Power > Advanced CPU Control > Active Processor Cores**</label>
-===== Enable/Disable CPU cores =====
+  <label bios_setup_path_for_g3>**Setup Utility > Advanced > Miscellaneous Configuration > State After G3**</label>
-{{section>.:..:bios_general#enable/disable_cpu_cores&noheader}}
+</embed>
-===== State After G3 =====
-{{section>.:..:bios_general#state_after_g3&noheader}}