This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision |
| en:x86:tqmxe38m:how_to [2018/10/31 13:44] – updated all contents schmid | en:x86:tqmxe38m:how_to [2020/04/21 10:59] – remove section howto, add template howto bujupib |
|---|
| </embed> | </embed> |
| \\ | \\ |
| \\ | <embed en:templates:bios_how_to> |
| ===== Boot from external BIOS ===== | <label lang>en</label> |
| {{section>.:data#boot_from_external_bios&noheader}} | <label bios_setup_path_for_usb>**Setup Utility > Advanced > USB Configuration**</label> |
| ===== Console Redirection ===== | <label bios_setup_path_for_emmc>**Setup Utility > Advanced > LPSS & SCC Configuration > SCC eMMC Boot Controller**</label> |
| {{section>.:..:bios_general#console_redirection&noheader}} | <label bios_setup_path_for_console>**Setup Utility > Advanced > Console Redirection > Enabled**</label> |
| ===== Hardware Monitor Fan Scaling ===== | <label bios_setup_path_for_hw_monitor>**Setup Utility > Advanced > SIO Hardware Monitor Nuvoton NCT7802Y > Enable Fan Scaling**</label> |
| {{section>.:..:bios_general#hardware_monitor_fan_scaling&noheader}} | <label bios_setup_path_for_cpu_cores>**Setup Utility > Power > Advanced CPU Control > Active Processor Cores**</label> |
| ===== Activate/Deactivate CPU cores ===== | <label bios_setup_path_for_g3>**Setup Utility > Advanced > Miscellaneous Configuration > State After G3**</label> |
| {{section>.:..:bios_general#activate/deactivate_cpu_cores&noheader}} | </embed> |
| ===== State After G3 ===== | |
| {{section>.:..:bios_general#state_after_g3&noheader}} | |