User Tools
Site Tools
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
en:x86:tqmxe38m:how_to [2020/04/15 15:06] bujupib change link section |
en:x86:tqmxe38m:how_to [2020/04/21 10:59] (current) bujupib remove section howto, add template howto |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| </embed> | </embed> | ||
| \\ | \\ | ||
| - | \\ | + | <embed en:templates:bios_how_to> |
| - | {{section>.:..:bios_general#how_to&noheader}} | + | <label lang>en</label> |
| + | <label bios_setup_path_for_usb>**Setup Utility > Advanced > USB Configuration**</label> | ||
| + | <label bios_setup_path_for_emmc>**Setup Utility > Advanced > LPSS & SCC Configuration > SCC eMMC Boot Controller**</label> | ||
| + | <label bios_setup_path_for_console>**Setup Utility > Advanced > Console Redirection > Enabled**</label> | ||
| + | <label bios_setup_path_for_hw_monitor>**Setup Utility > Advanced > SIO Hardware Monitor Nuvoton NCT7802Y > Enable Fan Scaling**</label> | ||
| + | <label bios_setup_path_for_cpu_cores>**Setup Utility > Power > Advanced CPU Control > Active Processor Cores**</label> | ||
| + | <label bios_setup_path_for_g3>**Setup Utility > Advanced > Miscellaneous Configuration > State After G3**</label> | ||
| + | </embed> | ||
Disclaimer
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
