Embedded module TQMxE40S Documentation
BIOS Overview
BIOS Overview
| BIOS Revision | BIOS Version | CSE Firmware Version | BIOS Binary |
|---|---|---|---|
| Rev. 0106 | 05.45.47.23.11 | 15.40.30.2879 | TQMxE40S_05.45.47.23.11.bin |
| Rev. 0105 ETH-PHY Quick-Fix-Release of Rev. 0104 | 05.43.49.16.09 | 15.40.16.2485 | TQMxE40S_05.43.49.16.09.bin |
| Rev. 0104 Not for Windows older than 21H2! | 05.43.49.16.06 | 15.40.16.2485 | TQMxE40S_05.43.49.16.06.bin |
| Rev. 0103 | 05.43.27.14.04 | 15.40.15.2416 | TQMxE40S_05.43.27.14.04.bin |
| Rev. 0102 | 05.43.27.14.03 | 15.40.15.2416 | TQMxE40S_05.43.27.14.03.bin |
| Rev. 0100 | 05.43.05.11.01 | 15.40.0.2204 | TQMxE40S_05.43.05.11.01.bin |
Changelog
Changelog
05.43.49.16.09
- improved power-on reset/initialization of Gigabit Ethernet PHys to avoid sporadic ‘PHY not detected’
05.43.49.16.06
- Insyde core update to version 05.43.49.0016
- integrate PINCTRL Patch → enabled
- close several security vulnerabilities
- Configure IRQs 7, 9 and 12
- fix high processor load when interrupt functionality enabled in EAPI driver
- Define USB overcurrent mapping table to COM Express spec
- Add additional SPD data for Micron MT53E512M32D1ZW_046
05.43.27.14.04
- Set Unique ID for INTC1020 Device (ACPI)
- Fix cross current flow on HPD pin
- Fix sporadic not working GBE Phy
05.43.27.14.03
- fix not booting system after flash update
- update GBE UNDI driver
- add fan control while booting
- Adapt setup menu
- Fix not working fan under OS (enable EC lite)
- Adapt pcie ports show in in SCU
05.43.05.11.01
- Remove PCIe_CLK_Req pins in GPIO initialization table
- Adapt SMBIOS data
- Adapt Setup menu
- Fix SD-Card issue
- SioTqmx86: Adapt to SMARC specification
- SioTqmx86: Remove USB0 host present information
- Fix not booting system when pressing power button
- Change Default configuration
- PCH TSN LAN Controller <Enabled>
- Enable TSN GBE in Fit
- Correct Memory SPD data
- Switch version shown to SMARC
- Adapt GOP config
- Set lane 8 (Host 0) to SGMII config in XML (CSE)
- Adapt GPIO configuration
- Correct output image name
- Adapt GPIO voltages
- Define DQS Map CPU to DRAM mapping on EOM config provided