To activate or deactivate eMMC Support apply the following settings:
1. Boot the system into the BIOS menu
2. Set up 'SCS/SCC Configuration' option in the BIOS Menu accordingly:
BIOS Frontpage > Setup Utility > Advanced (Tab) > PCH-IO Configuration > SCS Configuration > eMMC 5.1 Controller = <Enabled>
3. Press <F10> to save the settings and reboot the system
There are several ways to reset the UEFI firmware settings to the default values.
The UEFI settings can be reset by pressing F9 in the UEFI. You have to be in the Setup Utility Page to use this function.
To reset the settings without the display, proceed as follows:
When updating the UEFI firmware, the firmware defaults are loaded and all changes to the settings are lost.
Installing the same firmware resets these settings (e.g. UEFI update under Windows).
Our modules provide a function that allows to reset the UEFI to default values in case of emergency.
For this, the reset button must be pressed three times within one second.
If the module LED blinks red for a short time the reset to defaults was successful.