1. Connect a USB stick (FAT32 formatted) to the mainboard
2. Boot the system into the BIOS menu and move to the desired BIOS screen
3. Press <F11> to take a screenshot of the actual screen
4. Select the desired storage device in the pop-up window and press <Enter>

• Connect a USB stick (FAT32 formatted) to the mainboard
• Boot the System into the UEFI shell
• Press <F11> to take a screenshot of the actual screen
• Select the desired storage device in the pop-up window and press <Enter>

To activate or deactivate eMMC Support apply the following settings:

1. Boot the system into the BIOS menu
2. Set up 'SCS/SCC Configuration' option in the BIOS Menu accordingly:

 BIOS Frontpage > Setup Utility > Advanced (Tab) > PCH-IO Configuration > SCS Configuration > eMMC 5.1 Controller = <Enabled>

3. Press <F10> to save the settings and reboot the system

There are several ways to reset the UEFI firmware settings to the default values.

Option 1: Press F9

The UEFI settings can be reset by pressing F9 in the UEFI. You have to be in the Setup Utility Page to use this function.

To reset the settings without the display, proceed as follows:

1. hold ESC on the keyboard to enter UEFI (about 1min. to be safe)
2. Press the Down key at least 5 times
3. Press return to open the Setup utility
4. Press F9 and then press Return to load setup defaults
5. Press F10 and then Return again to save the settings and restart

Option 2: Update the UEFI Firmware

When updating the UEFI firmware, the firmware defaults are loaded and all changes to the settings are lost.
Installing the same firmware resets these settings (e.g. UEFI update under Windows).

Option 3: Reset via RESET button

Our modules provide a function that allows to reset the UEFI to default values in case of emergency.
For this, the reset button must be pressed three times within one second.
If the module LED blinks red for a short time the reset to defaults was successful.