This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. <embed en:templates:tabs_vxworks_bootstrap> <label lang>en</label> <label mod_name>tqma6x</label> <label mod_name_head>TQMa6x</label> <label mod_arch>arm</label> <label bsp_name>vxworks</label> <label bsp_name_head>VxWorks</label> <label product_type>Embedded module</label> <label build_system_head></label> </embed> \\ \\ ===== BSP Overview ===== <WRAP round important> due to licensing restrictions this BSP is available only on request </WRAP> ===== Bootloader ===== ==== u-boot Version ==== **u-boot 2013.04-20140226** ==== u-boot Features ==== ^Component ^ Status ^ Remarks ^ | CPU | + | i.MX6Q (Cortex<sup>(r)</sup>-A9) | | Ethernet | + | 1 x FEC (100 MBit working, GiGE under investigation) | | | + | USB - Ethernet Bridge | | eSDHC | + | SD card / eMMC | | UART | + | one for console | | I²C | + | EEPROM, Temperature Sensors | | GPIO | | custum configuration on request | | IIM/Fuse | - | on request | | SPI | + | SPI NOR Flash | | eMMC / SD boot | + | | | TFTP boot | + | | | SPI NOR boot | + | | | <wrap round info>Key: + tested %%|%% - untested %%|%% ? open</wrap> ||| ===== Operating System VxWorks 7 ===== <WRAP round important 45%> BSP has been created for STKa6Q (TQMa6Q + MBa6x) </WRAP> ^ TQ Product ^ Device ^ Interface ^ Function ^ Remarks ^ | TQMa6x | i.MX6 | ENET (X11) |RGMII (10/100/1000 Mbit/s) | |::: |::: | I2C3 | Bus access | |::: |::: | UART2 (X15) | |::: |::: | GPIO | |::: |::: | USB_OTG | Host | |::: |::: | USB_OTG | Client | |::: |::: | IPU1 | Parallel LCD |Display ET0700G0DH6 | |::: |::: | HDMI | HDMI |tested with 1280x1024 | \\ <WRAP round important leftalign 60%> the BSP kernel is configured for HDMI video output by default. You have to compile a new kernel for the parallel LCD. </WRAP> Last modified: 2022/08/04 15:02