Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
en:arm:tqma6x:vxworks:overview [2017/09/18 14:08] – created liedmann | en:arm:tqma6x:vxworks:overview [2022/08/04 15:02] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | <embed en: | + | <embed en: |
<label lang> | <label lang> | ||
<label mod_name> | <label mod_name> | ||
<label mod_name_head> | <label mod_name_head> | ||
<label mod_arch> | <label mod_arch> | ||
- | <label bsp_name> | + | <label bsp_name> |
- | <label bsp_name_head> | + | <label bsp_name_head> |
+ | <label product_type> | ||
+ | <label build_system_head> | ||
</ | </ | ||
\\ | \\ | ||
\\ | \\ | ||
+ | ===== BSP Overview ===== | ||
+ | <WRAP round important> | ||
+ | due to licensing restrictions this BSP is available only on request | ||
+ | </ | ||
+ | |||
+ | ===== Bootloader ===== | ||
+ | ==== u-boot Version ==== | ||
+ | |||
+ | **u-boot 2013.04-20140226** | ||
+ | |||
+ | ==== u-boot Features ==== | ||
+ | ^Component ^ Status ^ Remarks ^ | ||
+ | | CPU | + | i.MX6Q (Cortex< | ||
+ | | Ethernet | ||
+ | | | + | USB - Ethernet Bridge | | ||
+ | | eSDHC | + | SD card / eMMC | | ||
+ | | UART | ||
+ | | I²C | + | EEPROM, Temperature Sensors | | ||
+ | | GPIO | ||
+ | | IIM/ | ||
+ | | SPI | + | SPI NOR Flash | | ||
+ | | eMMC / SD boot | ||
+ | | TFTP boot | + | | | ||
+ | | SPI NOR boot | ||
+ | | <wrap round info> | ||
+ | |||
+ | |||
+ | ===== Operating System VxWorks 7 ===== | ||
+ | |||
+ | <WRAP round important 45%> BSP has been created for STKa6Q (TQMa6Q + MBa6x) </ | ||
+ | |||
+ | |||
+ | ^ TQ Product | ||
+ | | TQMa6x | ||
+ | |::: |::: | I2C3 | Bus access | ||
+ | |::: |::: | UART2 (X15) | | ||
+ | |::: |::: | GPIO | | ||
+ | |::: |::: | USB_OTG | ||
+ | |::: |::: | USB_OTG | ||
+ | |::: |::: | IPU1 | ||
+ | |::: |::: | HDMI | HDMI |tested with 1280x1024 | ||
+ | |||
+ | \\ | ||
+ | <WRAP round important leftalign 60%> | ||
+ | |||
+ | the BSP kernel is configured for HDMI video output by default. You have to compile a new kernel for the parallel LCD. | ||
+ | |||
+ | </ |