This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== MBa8Xx DIP switch settings ====== =====Boot Modes===== The following boot modes of the i.MX8X can be selected by the DIP switch S1 on the MBa8Xx. <grid> <col sm="2"> <panel type="primary" title="SD-Card"> <WRAP centeralign> [size=150%]**S1**[/size] {{ :en:dip_4_0011.png?nolink&150 |}} </WRAP> </panel> </col> <col sm="2"> <panel type="primary" title="eMMC"> <WRAP centeralign> [size=150%]**S1**[/size] {{ :en:dip_4_0010.png?nolink&150 |}} </WRAP> </panel> </col> <col sm="2"> <panel type="primary" title="QSPI NOR"> <WRAP centeralign> [size=150%]**S1**[/size] {{ :en:dip_4_0110.png?nolink&150 |}} </WRAP> </panel> </col> <col sm="3"> <panel type="primary" title="Serial Downloader"> <WRAP centeralign> [size=150%]**S1**[/size] {{ :en:dip_4_0001.png?nolink&140 |}} </WRAP> </panel> </col> <col sm="3"> <panel type="primary" title="Boot from Fuses"> <WRAP centeralign> [size=150%]**S1**[/size] {{ :en:dip_4_0000.png?nolink&140 |}} </WRAP> </panel> </col> </grid> ===== Functional DIP Switches ===== DIP-Switch settings for DP-Bridge and CAN. <grid> <col sm="6"> <panel type="primary" title="DSI-to-DP-Bridge (S9)"> <alert type="warning"> Only available on MBa8Xx Rev.01xx</alert> ^ DIP ^ S9 ^ | ON | enable DSI-to-DP-Bridge | | OFF | use LVDS interface | </panel> </col> <col sm="6"> <panel type="primary" title="CAN configuration (S7)"> DIP switch S7 is used to configure the CAN interfaces CAN1 and CAN2. ^ DIP ^ OFF (default) ^ ON ^ | S7-1 | CAN0 not terminated | CAN0 interface terminated (120Ω) | | S7-2 | CAN1 not terminated | CAN1 interface terminated (120Ω) | </panel> </col> </grid> Last modified: 2022/08/04 15:02