en

User Tools

Site Tools


vmware.png nfs.png tftp.png subversion.png eclipse.png logo.png tutorial.png

Embedded module TQMP1020 - Linux BSP documentation



Overview

Current versions & features

U-Boot 2012.10-rc1

Features

Component Status Remarks
CPU + 2 x e500v2 core
Ethernet + 3 x eTSEC
PCIe + 2 x
USB 2.0 + 1 x Host (mass storage)
eSDHC + SD card
STKP2020 rev 106+ required
eSPI -
DDR SDRAM + DDR3
PIC +
DUART + UART0
I²C + 2 x EEPROM, RTC, Temperature sensor
eLBC + NOR-Flash
Key: + tested | - untested | ? open

Linux 3.5.0

Features

Component Status Remarks
CPU + 2 x e500v2 core
Ethernet + 3 x eTSEC
PCIe + 2 x
USB 2.0 + 1 x Host
eSDHC ? currently not working
eSPI -
DDR SDRAM + DDR3
PIC +
DUART + UART0 (ttyS0), UART1 (ttyS1)
I²C + 2 x EEPROM, 2 x temperature sensor, RTC, GPIO expander
eLBC + NOR-Flash (MTD)
Key: + tested | - untested | ? open

en/power/tqmp1020/linux/overview.txt · Last modified: 2017/09/18 16:44 by liedmann


Disclaimer

TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.


Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Valid XHTML 1.0 Valid CSS Driven by DokuWiki