To activate or deactivate eMMC Support apply the following settings.
Setup Utility > Advanced > South Cluster Configuration > SCC Configuration
To activate Console Recirection in the BIOS via the serial port in addition to the display output on the Starterkit apply the following steps.
It can be useful for BIOS remote control tasks.
Setup Utility > Advanced > Console Redirection > Enabled
Bautrate: | 115200 |
---|---|
Data bits: | 8 |
Parity: | none |
Stop bits: | 1 |
Handshake : | XON/XOFF |
⇒ Reboot the Starterkit and use the terminal emulator to set up the BIOS
With 'Fan Scaling' option it is possible to control the system temperature at a certain load of the system by setting up the fan speed at certain trip points.
To create a custom 'Fan Scaling' plan apply the following steps in the BIOS setup.
Setup Utility > Advanced > SIO Hardware Monitor Nuvoton NCT7802Y > Enable Fan Scaling
To activate or deactivate CPU cores apply the following settings.
Setup Utility > Power > CPU Configuration > Core 0-4 > Enable/Disable
With 'State after G3' option you can specify the behaviour of the system after power is supplied.
Configuring 'State after G3:
State | Definition |
---|---|
S0 | System starts up directly after power is supplied |
S5 | System is held in power-off state until power button is pressed |
Setup Utility > Advanced > South Cluster Configuration > Miscellaneous Configuration > State After G3
1. Check if your module variant support LVDS:
BIOS Front Page > Device Manager > SIO TQmx86 > eDP to LVDS bridge = populated
2. Enable the LVDS inteface in SIO TQMx86:
BIOS Front Page > Device Manager > SIO TQmx86 > LVDS Configuration = <Enable>
3. Enable eDP to use the LVDS Interface (eDP-to-LVDS Bridge is used):
Setup Utility > Advanced (Tab) > Uncore Configuration > VBT Hook Configuration > LFP 1 Configuration = <eDP>
4. Press the changes by pressing the key F10 on your keybaord
The LVDS interface settings can be found on the following BIOS page:
BIOS Front Page > Device Manager > SIO TQmx86
Setting | Description |
---|---|
LVDS Color depth and data packing format | Change the color depth and data packing format acording to your display: > VESA 24 bpp > JEIDA 24 bpp > VESA and JEIDA 18 bpp |
LVDS dual/single mode | Select your LVDS bus mode: > Single > dual |
LVDS EDID information | EDID information includes display specific values like timing and resolution. They are normally located in an I2C EEPROM on the display or baseboard. The LVDS bridge offers you to emulate a set of different display resolutions without the need of an EEPROM. Turn EDID emulation on to use one of the display presets |
More information can be found under Custom LVDS resolution (EDID).