Embedded module TQMxE40S Documentation


BIOS Overview

BIOS Overview

BIOS Revision BIOS Version CSE Firmware Version BIOS Binary
Rev. 0106 05.45.47.23.11 15.40.30.2879 TQMxE40S_05.45.47.23.11.bin
Rev. 0105
ETH-PHY Quick-Fix-Release of Rev. 0104 		05.43.49.16.09 15.40.16.2485 TQMxE40S_05.43.49.16.09.bin
Rev. 0104
Not for Windows older than 21H2! 		05.43.49.16.06 15.40.16.2485 TQMxE40S_05.43.49.16.06.bin
Rev. 0103 05.43.27.14.04 15.40.15.2416 TQMxE40S_05.43.27.14.04.bin
Rev. 0102 05.43.27.14.03 15.40.15.2416 TQMxE40S_05.43.27.14.03.bin
Rev. 0100 05.43.05.11.01 15.40.0.2204 TQMxE40S_05.43.05.11.01.bin

Changelog

Changelog

05.45.47.23.11

  • Insyde Core Update to tag_05.45.47.0023
  • Fix not working Fan Control
  • Adapt RGMII Reset signal
  • Disable Advanced Boot Option
  • Add USB Overcurrent switche to SioTqmx86

05.43.49.16.09

  • improved power-on reset/initialization of Gigabit Ethernet PHys to avoid sporadic ‘PHY not detected’

05.43.49.16.06

  • Insyde core update to version 05.43.49.0016
    • integrate PINCTRL Patch → enabled
    • close several security vulnerabilities
  • Configure IRQs 7, 9 and 12
    • fix high processor load when interrupt functionality enabled in EAPI driver
  • Define USB overcurrent mapping table to COM Express spec
  • Add additional SPD data for Micron MT53E512M32D1ZW_046

05.43.27.14.04

  • Set Unique ID for INTC1020 Device (ACPI)
  • Fix cross current flow on HPD pin
  • Fix sporadic not working GBE Phy

05.43.27.14.03

  • fix not booting system after flash update
  • update GBE UNDI driver
  • add fan control while booting
  • Adapt setup menu
  • Fix not working fan under OS (enable EC lite)
  • Adapt pcie ports show in in SCU

05.43.05.11.01

  • Remove PCIe_CLK_Req pins in GPIO initialization table
  • Adapt SMBIOS data
  • Adapt Setup menu
  • Fix SD-Card issue
  • SioTqmx86: Adapt to SMARC specification
  • SioTqmx86: Remove USB0 host present information
  • Fix not booting system when pressing power button
  • Change Default configuration
    • PCH TSN LAN Controller <Enabled>
  • Enable TSN GBE in Fit
  • Correct Memory SPD data
  • Switch version shown to SMARC
  • Adapt GOP config
  • Set lane 8 (Host 0) to SGMII config in XML (CSE)
  • Adapt GPIO configuration
  • Correct output image name
  • Adapt GPIO voltages
  • Define DQS Map CPU to DRAM mapping on EOM config provided