| Device | Interface | Function | Status | Remarks |
|---|---|---|---|---|
| i.MX35 | AUART1 | RS232 - console output on MBa35CA | + | |
| i.MX35 | AUART2 | RS485 on MBa35CA | + | |
| i.MX35 | AUART3 | RS232 - console output on MBa35 | + | |
| i.MX35 | WEIM | connected with NOR on TQMa35 | + | |
| i.MX35 | ENET0 | 10/100Mbit Ethernet | + | |
| LAN9415 | ENET1 | 10/100Mbit Ethernet | + | |
| i.MX35 | CAN0 | Can 2.0B | + | |
| i.MX35 | CAN1 | Can 2.0B | + | |
| i.MX35 | GPIO | + | ||
| i.MX35 | I2C1 | Bus Access | + | |
| i.MX35 | I2C2 | LM79 EEPROM RTC | + + + | via I2C-2,Address: 0x48 via I2C-2,Address: 0x50 via I2C-2,Address: 0x68 |
| i.MX35 | IPU LCD | LCD Interface | + | |
| i.MX35 | SPI | TouchController | + | |
| i.MX35 | RTC | Real Time Clock | + via I2C-2 | |
| i.MX35 | SSI | Serial Audio Interface | - | on request |
| i.MX35 | IPU CSI | CMOS sensor Interface | - | on request, tested with custom design |
| i.MX35 | SD1 | SD - card on MBa35 | + | |
| i.MX35 | SD3 | eMMC on TQMa35 AB | + | |
| i.MX35 | USB0 | On The Go Interface | + | Mass Storage |
| i.MX35 | USB1 | Host Only | + | Mass Storage |
| SN75LVDS83B (MBa35) | LVDS | LVDS Interface | + | Tested with custom design |
| SGTL5000 (MBa35) | HP OUT / LINE OUT | Audio Output | $ | |
| SGTL5000 (MBa35) | MIC_IN | Microfon IN | $ | |
| Buzzer (MBa35) | GPIO0_24 | - | ||
| PCA9554 (MBa35) | GPIO | + | LVDS enable Tested with custom design |
Disclaimer
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.