FAQ
u-boot
Reset source handling
The i.MX53 System Reset Controller provides information about reset sources in the SRSR register. Mainline u-boot as of v2013.01 reads this register and resets information after reading to enable clean info at next boot. Decoding is done for single reset sources only. If your baseboard contains an supervisor which is connected to the reset input of the i.MX53 two reset sources (POR and IPP USER) are detected but not decoded - the reset source is reportes an “unknown”.
Disclaimer
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.