MBa6x RTC jumper settings
The MBa6x provides an RTC DS1339, though there is another RTC provided by the i.MX6.
As a backup supply for both RTCs a lithium battery is available. To connect the battery with the desired RTC you will need a jumper.
The pinstrip you have to bridge is located in between the battery cell and the SD-Card slot.
| X31 | RTC MBa6x | RTC i.MX6 |
|---|---|---|
| 1 | • | |
| 2 | • | • |
| 3 | • |
Jumper setting for RTC on MBa6x
Please consider the increased current consumption when using the RTC in the i.MX6. This leads to a fast discharge of the battery.
Disclaimer
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.