WinCE BSP aufspielen
- Terminal öffnen auf Baudrate achten
- Gerät in den U-boot Bootloader starten
http://support.tq-group.com/doku.php?id=en:arm:tqma28:linux:how_to#rescue_mode_without_dip_switches
- USB Kabel A-A an unteren USB Anschluss anstecken
- MFG Tool aus Demo Image Ordner starten
- Prüfen option emmc aktiv
- HID konformes Gerät wird in MFG TOOL erkannt
- START
- Im zuvor Geöffneten Terminal kann der Vorgang überwacht werden.
- Wenn Terminal folgendes zeigt
Whole update work is finisched successfully Please power off the board
- Board vom Strom abtecken und wieder anstecken WINCE Demo image bootet
Touchkalibrierung muss beim ersten Start einmalig durchgeführt werden.
Disclaimer
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.