STKA6X mit dem Test-Script testen
Material:
- GPIO Pinleiste
- CAN Brücke
- Display-Adapter mit Schalter
- Pinleiste mit Schalter
- VM mit laufendem iperf Server
- Script Datei (W:\EMB_SF\Starterkit_SD-Card-Images\STARTERKIT_TEST\MBA6x)
Vorbereitung
GPIO Pinleiste auf X30 stecken, Markierung bei Pin 1.
Pinleiste mit Schalter auf X28 stecken, Markierung bei Pin 1.
Display-Adapter auf X27 stecken.
Ethernet Kabel an den äußeren Ethernet-Port stecken ( = Eth0)
CAN-Brücke in X13 und X14 stecken (CAN1 & CAN2)
Auf der VM: iperf Server starten
Starterkit booten, Filesystem auf read-write umstellen, Script erstellen, dann Script ausführbar machen, starten und Anweisungen folgen:
>mount -o remount,rw / >nano Test.sh >chmod 777 Test.sh >./Test.sh
Möglicherweise hat sich seit dem letzten Test die IP-Adresse der VM geändert. Mit ifconfig in der VM überprüfen, ggf. Script auf dem Starterkit anpassen!
Disclaimer
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.