RCW anpassen
- RCW für SD/eMMC kann über folgende Datei im BSP angepasst werden : U-Boot-mmcsd.xxxx /board/tqc/tqmls102xa/ls102xa_rcw_sd.cfg
- Benötigtes Octet als Hexwert in Taschenrechner eingeben
- Layerscape Pinmultiplexing Tool öffnen und benötigte Werte ermitteln
- in oberen Bereich des Taschenrechners Bitfolge ändern und den entstanden Hexwert in rcw cfg datei eintragen
Disclaimer
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge. The software included in the shipment has been configured individually for the starter kits. The software is only intended to evaluate the module. The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH. TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.