Standard boot configuration SD Card
| S1 |
| DIP | ON | OFF |
| 1 | GPIO DIP 0 low | GPIO DIP 0 high |
| 2 | GPIO DIP 1 low | GPIO DIP 1 high |
| 3 | GPIO DIP 2 low | GPIO DIP 2 high |
| 4 | XFI_ENSMB# low | XFI_ENSMB# high |
| S2 |
| DIP | ON | OFF |
| 1 | DIU – Display Interface | TDM Interface |
| 2 | TBD – depends on software of system controller on TQMT1042 | - |
| 3 | T1024 USB-Clock | T1042 USB-Clock |
| 4 | Serdes PLL1 clock = 156.25 MHz | Serdes PLL1 clock = 100 MHz |
| S3 |
| DIP | ON | OFF |
| 1 | Lane C: SGMII | Lane C: QSGMII |
| 2 | Lane E: miniPCIe | Lane E: Aurora |
| 3 | Lane G: miniPCIe | Lane G: SGMII or SATA |
| 4 | Lane G: SGMII | Lane G: SATA |
| S4 |
| DIP | ON | OFF |
| 1 | DVDD=3.3 V | DVDD=1.8 V |
| 2 | EVDD=3.3 V | EVDD=1.8 V |
| 3 | CVDD=3.3 V | CVDD=1.8 V |
| 4 | SDHC Boot | Other Boot source |
Disclaimer
TQ-Systems GmbH provides the Board Support Packages (BSP) free of charge.
The software included in the shipment has been configured individually for the starter kits.
The software is only intended to evaluate the module.
The use of the Board Support Packages (BSP) is only allowed within the scope of functionality described by TQ-Systems GmbH.
TQ-Systems GmbH does not accept any liability for all further changes of the Board Support Package and for any damage resulting from its use.
